Make Sure It Fits Your Space
Complete measurement and installation preparation guide
Measure Twice
Always double-check your measurements
Check Connections
Verify electrical, water, and gas connections
Professional Install
Consider our expert installation service
Essential Measurements
Width Measurements
• Opening width: Measure the exact width of the space
• Add clearance: Allow 1/4" to 1/2" on each side for most appliances
• Cabinet width: For built-in units, measure interior cabinet dimensions
• Door clearance: Ensure appliance doors can fully open
Height Measurements
• Floor to ceiling: Measure total available height
• Cabinet height: Interior height for built-in appliances
• Countertop height: Standard is 36", but verify
• Overhead clearance: Check for range hoods, cabinets
Depth Considerations
• Measure from wall to front of countertop
• Account for wall irregularities
• Consider door swing clearance behind appliance
• Check for baseboard and trim interference
Refrigerators
• 1" clearance on sides
• 1" clearance on top
• French door swing space
• Water line access
Ranges/Cooktops
• 30" min clearance above
• Side clearances to cabinets
• Gas line positioning
• Electrical outlet location
Dishwashers
• Standard 24" wide opening
• 34" height clearance
• Plumbing access underneath
• Electrical connection nearby
Required Connections & Utilities
Electrical Requirements
Standard Appliances
• 115V/20A for most small appliances
• GFCI protection in wet areas
• Dedicated circuit recommended
High-Power Appliances
• 240V for electric ranges/dryers
• 30-50 amp service required
• Professional installation needed
Plumbing Connections
Water Supply
• Hot and cold water lines
• Shut-off valves accessible
• Proper water pressure (20-120 PSI)
Drainage
• Drain line with proper slope
• Air gap for dishwashers
• Garbage disposal compatibility
Gas Connections
Natural Gas
• Proper gas line sizing
• Shut-off valve within 6 feet
• Professional installation required
Propane (LP)
• Conversion kit may be needed
• Tank location considerations
• Local code compliance
Safety Requirements
Electrical Safety
• GFCI protection in kitchens, bathrooms
• Proper grounding for all outlets
• Arc-fault protection where required
Gas Safety
• Gas leak detection equipment
• Proper ventilation requirements
• Professional leak testing
Space Preparation
Before Installation
• Clear the path: Remove obstacles from delivery route
• Protect floors: Use cardboard or moving blankets
• Remove old appliance: Disconnect and remove safely
• Clean the space: Vacuum and wipe down area
• Check utilities: Test all connections
Installation Day
• Be present: Available for questions and access
• Clear workspace: Give installers room to work
• Have tools ready: Basic tools may be needed
• Test everything: Verify all functions work
• Ask questions: Get operating instructions
Columbus Area Considerations
• Older homes may need electrical upgrades
• Basement access for utilities common
• Local code requirements vary by suburb
• Seasonal delivery scheduling recommended
Common Installation Issues
• Uneven floors requiring leveling
• Cabinet modifications needed
• Electrical panel upgrades required
• Plumbing relocations necessary
Pre-Purchase Checklist
Measurements
Width measured (with clearances)
Height measured (with clearances)
Depth measured (with clearances)
Door swing clearance checked
Delivery path measured
Utilities
Electrical requirements verified
Plumbing connections available
Gas line ready (if needed)
Ventilation adequate
Safety requirements met
Need Professional Help?
Free Services Include:
• Pre-purchase space consultation
• Measurement verification
• Utility requirements assessment
• Delivery scheduling
Professional Installation:
• Complete appliance installation
• Electrical and plumbing connections
• Old appliance removal and disposal
• Full testing and warranty
Download Our Complete Guide
Get our comprehensive PDF measurement guide for reference during your shopping.